Operation - Makita 3708F Instruction Manual

OPERATION

1
2
1. Trimmer shoe
2. Base
8
Installing trimmer shoe (after it has been removed
from the tool)
1
2
1. Bolt
3. Trimmer shoe
5. Spring washer
7. Base
NOTE:
• The trimmer shoe is factory installed on the tool.
Use the bolts, wing nuts, spring washers and flat washers to
install the trimmer shoe as shown in the figure.
Turn the tool on without the bit making any contact with the
002005
workpiece and wait until the bit attains full speed. Then move
the tool over the workpiece surface, keeping the tool base
and trimmer shoe flush with the sides of the workpiece.
NOTE:
• This tool can be used as a conventional trimmer when
you remove the trimmer shoe.
When doing edge cutting, the workpiece surface should be
on the left side of the bit in the feed direction.
1
1. Workpiece
3. View from the top of the tool
3
4
4
2
3
002004
5
6
7
2. Flat washer (large)
4. Flat washer (small)
6. Wing nut
001984
2
4
2. Bit revolving direction
4. Feed direction