Replacing Carbon Brushes; Maintenance - Makita RT0700C Instruction Manual

Hide thumbs Also See for RT0700C:

Table of Contents

For the plunge base (optional accessory)

► 1. Dust nozzle 2. Thumb screw

Use the dust nozzle for dust extraction. Install the dust

nozzle on the tool base using the thumb screw so that

protrusion on the dust nozzle it to the notch in the tool

base.

Then connect a vacuum cleaner to the dust nozzle.

CAUTION:

•

Always be sure that the tool is switched off and

unplugged before attempting to perform inspec-

tion or maintenance.

•

Never use gasoline, benzine, thinner, alcohol

or the like. Discoloration, deformation or cracks

may result.

Replacing carbon brushes

► 1. Limit mark

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

► 1. Screwdriver 2. Brush holder cap

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be per-

formed by Makita Authorized Service Centers, always

using Makita replacement parts.

15 ENGLISH

Table of Contents