Advertisement
ADDITIONAL SAFETY RULES
FOR CORDLESS TRIMMER
1. Be aware that this tool is always in an operating condition, because
it
does
2.
Handle the bits very carefully.
3.
Check the bit carefully for cracks or damage before operation. Replace
4.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
5.
Hold the tool firmly.
6.
Keep hands away from rotating parts.
7.
Make sure the bit is not contacting the workpiece before the switch is turned
8.
Before using the tool on an actual workpiece, let it run for a while. Watch
9.
Be careful of the bit rotating direction and
the
feed direction.
not have t o be plugged into an electrical outlet.
cracked or damaged bit immediately.
fore operation.
on.
for vibration or wobbling that could indicate improperly installed bit.
10. Do
not leave the tool running. Operate the tool only when hand-held.
11.
Always switch off and wait for the bit t o come t o a complete stop before
12. Do
not touch the bit immediately after operation,
it
may be extremely hot
13.
Keep the bit retracted so as not t o protrude from the tool base except dur-
removing the tool from workpiece.
and could burn your skin.
ing actual operation.
SAVE THESE INSTRUCTIONS.
6
Advertisement
