Advertisement
Operation
o s e t
the tool base on the workpiece to be cut without the bit making any contact. Then
turn the tool on and wait until the b i t attains full speed. Move the tool forward over the
workpiece surface, keeping the tool base flush and advancing smoothly until the cutting
is complete.
0
When doing edge cutting, the workpiece surface should be on the left side of the bit in
the feed direction. (See the figure below.)
Feed direction
(View from
the
top of the tool)
(3
Bit revolving
direction
I
Correct bit feed direction
NOTE :
0
Moving the tool forward too fast may cause a poor quality of cut, or damage t o the bit
or motor. Moving the tool forward too slowly may burn and mar the cut. The proper
feed rate will depend on the bit size, the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece,
it i s
advisable to make a sample cut on a
piece of scrap lumber. This will show exactly how the cut will look
as
well as enable you
to check dimensions.
.When using the straight guide or the trimmer guide, be sure to install it on the right side
in the feed direction. This will help to keep
it
flush with the side of the workpiece.
CAUTION
:
I f the tool i s operated continuously until the battery cartridge has discharged, allow the
tool to rest for 15 minutes before proceeding with
a
fresh battery.
10
Advertisement
