To Configure A Rapid Eye Site's Camera(S); To Obtain Video From A "Live Video Session - Honeywell RAPID EYE K9696V2 Installation Instructions Manual

Multi-Media Unit: Installation Instructions

!43 To configure a Rapid Eye site's camera(s)

1.
2.
3.
3.3.6 Obtaining Video

!44 To obtain video from a "live video session"

1.
2.
3.
Fig. 36. Live video from a camera, renamed to "side entrance", at a site called: "Foucault
facility, 232".
3–16
Run a maintenance session at the pilot site.
Click the Video tab and adjust Picture controls as needed. See figure 35. The
adjustments are made on the fly; you do not need to click the Apply/Reset
button, as for older Multi-Media units.
You have the option of ending the Maintenance session for the Multi-Media unit.
Start by obtaining the list of cameras at the site. Either:
Right-click on the site name to select Live from the shortcut menu.
Select the site; then click Live on the Actions menu.
Selecting the site; then click
Select cameras as required. Click OK. Video should appear. See figure 36.
End the Live session by closing the Live window or View.
on the toolbar.