Connection Ports And Reset Button - NETGEAR Trek PR2000 User Manual

Trek N300 Travel Router and Range Extender PR2000
Table 1. Status LEDs (continued)
WiFi LED
• Green. Either the LAN port or a wireless device is connected to the Trek.
• Off. No device is connected.
USB LED
• Green. The USB drive is properly mounted.
• Off. No USB drive is detected.

Connection Ports and Reset Button

Connect or reset your Trek.
Reset
button
Connection
ports
Figure 4. Connection ports and Reset button
Connect or reset your Trek using the following items:
• Reset button. To reset the Trek to its factory settings, insert a paper clip into the Reset
hole and hold it until the Internet LED blinks. See
information about restoring factory settings.
• Internet/LAN port. When the Internet via switch is set to Wired, this port becomes an
Internet port. When the switch is set to Wireless, this port becomes a LAN port for any
Ethernet-enabled device.
• LAN port. A LAN port for any Ethernet-enabled device.
• USB port. A USB port for USB storage or a USB printer. When the Trek is plugged into
the wall, the USB port can also be used as a cell phone charger.
Factory Settings
Hardware Setup
12
on page 143 for