Cross Link Video Input Modules; Figure 3-4 Type A, B And C Cross-Link Looping Input Termination Modules - Honeywell VideoBloX User Manual

CROSS LINK VIDEO INPUT MODULES

LINK 1-16
INPUT
LOOP OUT LINK 1-16
INPUT
16 15 14
INPUT
Rev 1.0
The looping card allows for looping of video inputs to another matrix switcher chassis or to
an external video device, such as a VCR, DVR or multiplexer. Note that if a looping
termination card is installed, a blank cover plate will be needed above the input card on the
front of the chassis.
Different rear terminations can be used with each input card to alter the connection method
to the chassis or card. The standard video input is connected by means of a BNC connector
mounted on the rear termination panel.
When a system requires more than 64 video outputs (the maximum allowed in a single
rack), cross-looping input rear termination modules may be used. These modules allow for
a cross-connection of 8 video inputs from each of the style 'A' and 'C' modules. When
connected using coaxial ribbon cables, each chassis receives all 16 video inputs. The 'B'
style cross-connection module allows for interconnection of up to 4 VideoBloX chassis.
Figure 3-4 Type A, B and C Cross-Link Looping Input Termination Modules
CROSS LINK STYTLE 'A' INPUT
13 12 11 10
The following drawings show examples of how the Cross-Link Video Input Modules are
installed when more than 64 video outputs are required.
VideoBloX Chassis Only User Manual
8
7 6
CROSS LINK STYTLE 'B' INPUT
9
CROSS LINK STYTLE 'C' INPUT
19
5 4 3 2 1
LOOP OUT LINK 1-16
900.0855
10/06