Termination; Fuses; Figure 3-9 Video Gain Adjustment - Honeywell VideoBloX User Manual

VIDEO INPUT MODULES

Termination

FUSES

Rev 1.0
Figure 3-9 Video Gain Adjustment
The termination switch SW1 should be set to On (75 ohm) position unless the input is
looped to other video products. Should the input be looped to another device, then ensure
that the signal is terminated only at one position. The termination should always be set to
on at the last video device. Refer to
The input module has one PCB mounted fuse, rated at 4A. This fuse should only blow in
the event of a fault on the board. In such an event the input module should be returned to
Honeywell for repair.
Figure 3-8 for an illustration of termination switch SW1.
26 900.0855
10/06