Dip Switch Settings; Figure 2-5 Chassis Dip Switch Settings; Table 2-2 Dip Switch Settings; Table 2-3 Chassis Sync Signal - Honeywell VideoBloX User Manual

REAR CHASSIS

DIP SWITCH SETTINGS

Rev 1.0
Various parameters which are common to the entire chassis are
configured by means of the 4-way DIP switch as per the following tables:
Table 2-2
Backplane Baud Rate
9600 Baud
19.2 KB (Default)
57.6 KB
115.2 KB
When multiple VideoBloX chassis are interconnected, use switch 4 to set the chassis, which
contains the CPU card, to be the master. All other chassis must be set up as slaves.
Use switch 3 to determine which chassis generates / receives the system synchronization
signal. This signal is used to synchronize video matrix switch operations to occur during the
vertical synchronization period of the video signals.
Switch Position
3
4

Figure 2-5 Chassis DIP Switch Settings

DIP Switch Settings
Switch 2 Switch 1
Off Off
Off On
On Off
On On
Table 2-3 Chassis Sync Signal
Off
Chassis generates system
sync signal
Chassis is a master
14
On
Chassis receives system
sync signal
Chassis is a slave
900.0855
10/06