Reset Push Button; Sync Phase Adjustment; Figure 2-6 System Reset Push Button; Figure 2-7 Sync Phase Adjustment - Honeywell VideoBloX User Manual

RESET PUSH BUTTON

SYNC PHASE ADJUSTMENT

Rev 1.0
When this button is pressed, the chassis will be reset.
Should the chassis be configured as a master, then all
slave chassis will also receive a reset signal.
This adjustment determines the sync phase with
respect to the mains waveform. When sync is received
via the rear panel "Chassis Sync In" BNC or via the
"Control" connector, this adjustment will have no effect.
VideoBloX Chassis Only User Manual

Figure 2-6 System Reset Push Button

Figure 2-7 Sync Phase Adjustment

15
Black Reset
Push
Button
Sync Phase
Adjustment
900.0855
10/06