Replacing Sfp Modules Into Sfp Module Slots - Cisco 3200 Series Hardware Reference Manual

Replacing SFP Modules into SFP Module Slots

This section describes how to replace an SFP module.
Class 1 laser product. Statement 1008
Warning
To insert an SFP module into the SFP module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 1
Remove the antenna end cap by using a 3/8-in. wrench to loosen the bolts.
Step 2
Disconnect the LC from the SFP module.
Step 3
Tip
Step 4 Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Caution
Unlock and remove the SFP module.
Step 5
Figure B-2
A
Pull the bale-clasp latch out and down to eject the module. If the bale-clasp latch is obstructed and you
Step 6
cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module
Step 7
slot.
Step 8 Place the removed SFP module in an antistatic bag or other protective environment.
Caution
Cisco 3200 Series Router Hardware Reference
B-2
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Do not touch the optical surfaces.
Disconnecting SFP Latch Mechanisms
1
B
Do not remove the rubber plugs from the SFP module port or the rubber caps from the
fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP
module ports and cables from contamination and ambient light.
2
Appendix B SFP Module Replacement
3 4
OL-5816-10