Hnb Gw Service Configuration; Iuh Interface Configuration - Cisco ASR 5000 Series Administration Manual

▀ HNB GW Service Configuration

HNB GW Service Configuration
HNB-GW services are configured within source contexts and allow the system to function as an HNB-GW in the 3G
UMTS wireless data network.
I
that allows the system to process bearer contexts with IPsec authentication on SeGW. Commands that
configure additional HNB-GW service properties are provided in the different chapters of Command Line
Interface Reference.
These instructions assume that you have already configured the system level configuration as described in System
Administration Guide.
To configure the system to work as HNB-GW service with SeGW enabled:
Step 1
Create an interface in source context for Iuh interface by applying the example configuration in the Iuh Interface
Configuration section.
Step 2
Configure SS7 routing domain by applying the example configuration in the SS7 Routing Domain Configuration
section.
Step 3 Configure SCCP network id with national variant by applying the example configuration in the SCCP Network Instance
Configuration section.
Step 4
Configure CS network parameters by applying the example configuration in the HNB-CS Network Configuration
section.
Step 5
Configure PS network parameters by applying the example configuration in the HNB-PS Network Configuration
section.
Step 6
Configure GTP-U service parameters by applying the example configuration in the GTP-U Service Configuration
section.
Step 7
Create and configure the HNB-GW service and associate related parameters with HNB-GW by applying the example
configuration in the HNB-GW Service Configuration section.
Step 8
Optional. Configure Security Gateway parameters with Crypto-template and enable SeGW by associating it with HNB-
GW to enabling SeGW by applying the example configuration in the Security Gateway and Crypto Template
Configuration section.
Step 9
Verify your HNB-GW configuration by following the steps in the HNB-GW Service Configuration Verification section.
Step 10
Save your configuration as described in the Verifying and Saving Your Configuration chapter.

Iuh Interface Configuration

Use the following example to configure the Iuh interfaces in source context:
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
:
MPORTANT
This section provides the minimum instruction set for configuring an HNB-GW service
HNB-GW Service Configuration Procedures
OL-22991-01