Required System-Level Configuration Information - Cisco ASR 5000 Series Administration Manual

HNB-GW Service Configuration Procedures

Required System-Level Configuration Information

The following table lists the information that is required to configure at the system-level Global configuration mode
(context independent) to support 3G UMTS Femto support.
Table 2. Required Information for System Configuration
Required Information Description
SS7 Routing Domain Configuration
SS7 Routing An identification for SS7 routing domain and must be an integer between 1 and 12 by which the SS7
Domain id and routing domain will be identified and configured.
variant A variant can be configured for the SS7 routing domain. some of them are:
Sub Service Field A network indicator in the subservice field for SS7 message signal units (MSUs).
(SSF) It can be configured with any of the following indicators:
Applicaiton Server An M3UA Application Server Process (ASP) instance idenfied from 1 through 4.
Process (ASP) This instance need to configure end point address as well.
instance
Peer server id Specifies a peer server instance to setup a SIGTRAN peer for sending and receiving M3UA traffic. Up to
49 peer servers can be defined.
A peer server id configuration may contain:
OL-22991-01
ansi: American National Standards Institute (U.S.A.)
bici: Broadband Intercarrier Interface standard
china: Chinese standard
itu: International Telecommunication Union (ITU-T) Telecommunication Standardization Sector
ntt: Japanese standard
ttc: Japanese standard
International
National
Reserved
Spare
Routing context for peer server to use
Self point code in SS7 type address
Operational Mode
Peer Server Process (PSP) instance
Information Required to Configure the System as an HNB-GW ▀
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄