Cisco ASR 5000 Series Administration Manual page 52

▀ Information Required to Configure the System as an HNB-GW
Required Information Description
Iuh Interface Configuration (To/from Home-NodeB)
HNB-GW service An identification string from 1 to 63 characters (alpha and/or numeric) by which the HNB-GW service can
Name be identified on the system. It is configured in Context configuration mode.Multiple names are needed if
multiple HNB-GW services will be configured.
HNB-GW Service Configuration
Iuh interface IP IPv4 addresses assigned to the Iuh interface as SCTP bond address.
address This address will be used for binding the SCTP (local bind address(es)) to communicate with the HNBs
using GTP-U.The HNB-GW passes this IP address during setting up the SCTP association with the HNB.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Iuh SCTP Port The physical port to which the Iuh interface will be bound. The local SCTP port used to communicate with
the HNBs over Iuh interface.
RTP IP address This is the IP address of HNB-GW which is configured as RTP address and sent to HNB to map the RTP
streams with this IP address on HNB-GW. This configuration is required at HNB-GW to communicate
with MSC/VLR over IuCS-over-IP tunnel.
Optional Security Gateway Configuration
Security Gateway IP This is the IP Address where the SeGW service is bound and shall be provided to HNB during SeGW-
address Discovery.
Only one SeGW IP address can be configured.
IPsec Crypto-map Template Configuration
EAP profile This is the profile to be used to provide authenticator modes for incoming packets on Security Gateway.
Only one EAP profile can be configured.
IP Pool for IPsec Specifies the IP pool to assign IP address for IPsec traffic to use.
Tunnel
IKEv2 Transform IKEv2 transform set for IKE security association.
set
IPsec Crypto-map Specifies the Crypto-map template to be used for IPsec IKEv2 tunneling for the interface configured as an
Template Iuh.
This crypto-map template is to be associated with HNB-GW service if SeGW is enabled and bind with
HNB-GW service.
Only one IPsec Crypto-map Template can be configured.
AAA Server Group Specifies the name of the context in which a AAA server group is configured for association with SeGW
Context name for AAA parameters during subscriber authentication phases.
AAA Server Group Specifies the AAA server group already configured in a context and is to be used for first/second phase of
name authentication of subscriber while using SeGW functionality in an HNB-GW service.
Radio Network PLMN Configuration
Public Land Mobile
Mobile Country Code (MCC): The MCC can be configured to any integer value from 0 to 999.
Network (PLMN)
Mobile Network Code (MNC): The MNC can be configured to any integer value from 0 to 999.
Identifiers
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
HNB-GW Service Configuration Procedures
OL-22991-01