Table of Contents
Advertisement
S
O
CALE
PERATION
S
S
I
ECURITY
EAL
NSTALLATION
The certification of the weighing mechanism of the scale version of this scanner is subject to federal, state and local Weights
and Measures statutes and regulations and can only be performed by authorized government agencies and/or their duly
registered agents. Each time the scale or weighing mechanism is calibrated, it should be properly sealed with a paper seal or a
wire seal prior to being placed into service in commerce.
It is the responsibility of the owner of the scale to confirm compliance with the relevant Weights and Measures statutes and
regulations applicable in your area by checking with the appropriate government agency before placing a newly calibrated unit
into service or removing any official seals.
Type of seal to be used will depend on the guidelines specified by the local Weights and Measures authorities.
The security seal must only be installed if there were no errors during the scale calibration verification tests.
Pressure Sensitive Security Seal*
1.
Temporarily remove the platter and place it in a safe location.
2.
Apply the adhesive calibration security seal over the calibration
button access hole (see Figure 57).
3.
With very light pressure, push down on the adhesive calibration
security seal label to ensure a firm adhesion is created
(see Figure 58).
4.
Reinstall the platter.
* These procedures are for MS2320 StratosH Scanner/Diva Scale models only
50
Figure 59. Platter Installation
.
Figure 57.
Figure 58.
Advertisement
Table of Contents
