Table of Contents
Advertisement
I
NSTALLATION
C
I
(I
ABLE
NSTALLATION
RS232
9.
Turn on the host system.
10. Scan the Recall Defaults bar code.
The Recall Defaults bar code is located in the MetroSelect Configuration Guide (
11. Configure the StratosH to match the host system's RS232 parameters.
Refer to the MetroSelect Configuration Guide (
the recall defaults bar code first).
xxx* Specifies international connection. See page 3 for a complete listing of power supply options and their part numbers.
**
See page 3 for information on optional display types and part numbers.
See power source caution statement on page 9 of this manual.
S
)
NTERFACE
PECIFIC
Figure 20. RS232 Interface Cable Installation Schematic
00-02407x) under Section G: RS232 for Enabling RS232 Mode (scan
PN
00-02407x), under Need to Start Over.
PN
17
Advertisement
Table of Contents
