S
O
CANNER
PERATION
IR A
A
(IR LED O
CTIVATION
REA
The StratosH's default power save mode
OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals. Any movement detected by the IR in
the activation area, shown below, will cause the scanner to exit the power save mode. The motor will restart automatically and the
laser will turn back on preparing the scanner for bar code recognition, decoding and transmission.
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.
Specifications are subject to change without notice
30
)
UTPUT
†
is Dual Action Power Save Mode #2 (see page 35). This power save mode
Figure 31. IR Activation Area Perpendicular to Package Flow (IR LED Output)
.
†
turns the laser