Table of Contents
Advertisement
S
O
CALE
PERATION
C
ALIBRATION
Bar Code Calibration Procedure without Remote Display*
4.
Reinstall the platter onto the scanner/scale (see Figure 49).
5.
Enter bar code calibration mode. Use the vertical window to scan one of the following bar codes, whichever weight units (either
pounds or kilograms) the scanner/scale will be operating in. The scanner will beep once as it enters the bar code calibration mode
and the calibration utility will start.
Unit Calibration (Pounds)
For Kilogram weight units see instructions on page 46.
Pounds Calibration
³
9
9
6
If a razz tone sounds, an error has occurred. Refer to Diagnostic Indicator Display; Error Codes starting on
page 33 for additional information.
* These procedures are for MS2320 StratosH Scanner/Diva Scale models only
0
4
2
Figure 49. Platter Installation
Figure 50. Entering Bar Code Calibration Mode (Pounds)
.
45
Advertisement
Table of Contents
