Vol Co 2 (Co 2 Sensors Only); Vol Ch 4 (Lel Sensors Only); Correction Factor (Cf) - Honeywell GasAlertMicro 5 User Manual

GasAlertMicro 5/PID/IR
User Manual
%Vol CO (CO Sensors Only)
2
2
If the %vol CO is enabled, the detector
2
displays the carbon dioxide (CO
readings as %vol (0.0).
From the Sensors option menu, select
CO .
2
Press H to scroll to %vol CO
to toggle between enable and disable.
Confirmation is not required. If no buttons
are pushed, after 20 seconds the detector
returns to the sensor selection screen.
The change is saved automatically.
The detector is shipped with %vol CO
disabled.
Correction factors are not applicable to the CO
28
)
2
. Press C
2
2
Enable 
Disable 
Note
sensor.
2
%Vol CH (LEL Sensors Only)
4
If %vol CH is enabled, any currently
4
enabled correction factor is ignored and
the detector operates assuming a
methane (CH ) calibration.
4
From the Sensors menu, select LEL and
press C to confirm.
Next, press H to scroll to %vol CH
press C within 20 seconds to confirm.
Press C to toggle between enable and
disable.
Confirmation is not required. If no buttons
are pushed within 20 seconds, the
detector returns to the sensor selection
screen. The change is saved
automatically.
The detector is shipped with %vol CH
disabled.

Correction Factor (CF)

Depending upon the selected sensor, refer to the following sections
LEL Sensor or PID Sensor for more information.
Corrections factors are not applicable to CO
and
4
Enable 
Disable 
4
Note
sensors.
2