Ce Enable Auto Boot; Ce Enable Auto Synch - HP NetServer AA 4000 Administrator's Manual

Chapter 5

CE Enable Auto Boot

This command enables Auto Boot for a specific CE. Auto Boot allows the CE to automatically
boot the CE's Windows NT operating system after a reboot or power cycle. By default, Auto
Boot is true (enabled).
Command CEn Enable Auto Boot From IOPx
Console Syntax MTCCONS CEn Enable Auto Boot From IOPx
n – the ID number of the CE (1 or 2)
Variables
x – the ID number of the IOP (1 or 2)
Results To verify that Auto Boot has been enabled for CEn, issue a CEn Show Auto
Boot or CEn Show Parameters command from either IOP.
See Also
CE Disable Auto Boot
CE Show Auto Boot
CE Show Parameters

CE Enable Auto Synch

This command enables Auto Synch for a specific CE. Auto Synch allows the second CE to
automatically attempt to synchronize with the running CE. By default, Auto Synch is true
(enabled).
Command CEn Enable Auto Synch From IOPx
Console Syntax MTCCONS CEn Enable Auto Synch From IOPx
Variables n – the ID number of the CE (1 or 2)
x – the ID number of the IOP (1 or 2)
To verify that Auto Synch has been enabled for CEn, issue a CEn Show Auto
Synch or CEn Show Parameters command from either IOP.
See Also
CE Disable Auto Synch
CE Show Auto Synch
CE Show Parameters
Commands
83