Ce Disable Auto Boot - HP NetServer AA 4000 Administrator's Manual

Chapter 5

CE Disable Auto Boot

This command disables Auto Boot for a specific CE. Auto Boot allows the CE to automatically
boot the CE's Windows NT operating system after a reboot or power cycle. If you disable Auto
Boot, the operating system cannot be booted on this CE until you issue a CE Enable Auto Boot
command. If you are setting this option to prevent a CE from joining the server configuration,
make sure that you disable both Auto Boot and Auto Synch
in certain scenarios, the CEs can boot and synchronize.
By default, Auto Boot is true (enabled).
Command CEn Disable Auto Boot From IOPx
Console Syntax MTCCONS CEn Disable Auto Boot From IOPx
Variables n – the ID number of the CE (1 or 2)
x – the ID number of the IOP (1 or 2)
To verify that Auto Boot is disabled for CEn, issue a CEn Show Auto Boot
Results
or CEn Show Parameters command from either IOP.
See Also
CE Disable Auto Synch
CE Enable Auto Boot
CE Show Auto Boot
CE Show Parameters
80
(page 81) on that CE. Otherwise,
Commands