Iopn.monitor Show Auto Start - HP NetServer AA 4000 Administrator's Manual
Hp netserver aa 6200 solution release 3.0 administrator’s guide
Hide thumbs
Also See for NetServer AA 4000:
- Manual (386 pages) ,
- Reference manual (142 pages) ,
- Installation manual (82 pages)
Table of Contents
Advertisement
Chapter 5
IOPn.Monitor Show Auto Start
This command displays the Auto Start setting for the specified IOP.
•
If Auto Start is true (enabled), the specified IOP does not wait for the other IOP, and it
continues processing software.
•
If Auto Start is false (disabled) and the other IOP is not faulted or disabled, the specified
IOP waits indefinitely to initialize with the other IOP.
By default, Auto Start is disabled.
Command
IOPn.Monitor Auto Start -disable_safeguard
Console Syntax MTCCONS IOPn.Monitor Show Auto Start -disable_safeguard
n – the ID number of the IOP (1 or 2)
Variables
x – the ID number of the IOP (1 or 2)
For an example of the results of this command, refer to
Results
Parameters
See Also
IOPn.Monitor Disable Auto Start
IOPn.Monitor Enable Auto Start
IOPn.Monitor Show Parameters
146
on
page
152.
Commands
IOPn.Monitor Show
Advertisement
Table of Contents
