Table of Contents
Advertisement
2.
locate 1.25 Mp on the chart below.
lever & dial
positions
F lever
position
position
figure 98. 16 tpi and corresponding lever and
dial positions.
3.
to the left of 1.25 Mp, locate the f lever in
the left position, and G dial in the 4 position.
above 1.25 Mp, locate the E lever in the 2
position (see figure 98).
Note: In the next step, rock the chuck back
and forth so the gears will mesh together.
Model G0746/G0749 (Mfg. Since 3/13)
E lever position
1.25 Mp
g dial
4.
position the gearbox levers and dials, as
shown in figure 99.
F lever
position
g dial
position
˶
mm
F
Lever
G
G
Dial
figure 99. lever and dial settings for 1.25 Mp.
5.
Move the leadscrew feed rod selection lever
up.
the lathe is now set up to turn 1.25 Mp.
E lever
position
selection
lever
3
2
1
E
Lever
Leadscrew (UP)
Feed Rod (DOWN)
Selection Lever
-61-
Advertisement
Table of Contents
