GE AEE08 Owner's Manual & Installation Instructions page 9

Window Installation Instructions
13] REMOVE THE AIR CONDITIONER
FROM THE CASE (CONT.)
[] Remove and save the ground wire screw.
[i.
Ground L _
wire _
Ground
screw
Illl++ll
IUl#{I
IllllJll
IIl_ltll
iiIlm+
IIMII+
II_llll+
_Jllll+
_ FRONT
r_ Slide the air conditioner from the case by
gripping the base pan handle and pulling
forward while bracing the case. Do not
pull or lift on the styrofoam discharge area.
Do not
pull or
lift in
this
area-
damage
to the
unit may
result
FRONT
_] INSTALLTHE BOTTOM
CASE SEAL
• Peel the backing from the bottom
case seal and attach it along the
bottom of the case in front of the
bottom mounting rail.
Bottom
mounting
Bottom case seal
I-5]INSTALL THE TOP MOUNTING
RAIL ONTO THE CASE
Attach the top mounting rail onto the top
of the case with 3Type B screws.
Press firmly to drive the screws into the
gasket and through the top mounting rail.
3e B
screws
[] INSTALL THE
SIDE ACCORDION PANELS
IA1 Slide the left and right accordion panels
into the top and bottom mounting rails.
r_ Attach the accordion panels to the case
using 3Type A screws on each side.
Top mounting rail
Accordion
panel
Type A
screws
\\
BACK
Bottom mounting rail
9