GE AEE08 Owner's Manual & Installation Instructions page 8

Window Installation Instructions
ITI WINDOW REQUIREMENTS
• These instructions are for a standard
double-hung window.You will need to
modify them for other types of windows.
CAUTION:
If the sill support
bolts do not contact the window sill or
if you have a window without a sill, you
must order accessory kit RAK87 to
properly install this air conditioner.
Call 800.626.2002 or visit ge.com.
All supporting parts must be secured
to firm wood, masonry or metal.
The electrical outlet must be within
reach of the power cord.
17" min.
27" to 36"
(With accordion panels)
i i
[] STORM WINDOW REQUIREMENTS
A storm window frame will not allow the
air conditioner to tilt toward the outside,
and will keep it from draining properly.
To adjust for this, attach a piece of wood
to the stool.
WOOD PIECES-
WIDTH: 2"
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness,
place a piece of wood on the stool to
make it 1/2" higher than the top of the
storm window frame or the vinyl frame.
Attach securely with nails or screws
provided by the installer.
1/2" higher
than vinyl frame
L (on some windows)
/
w
1/2"higher ______ _ _Wood
than storm
window !1
frame _St°°l FT _
Storm window
frame - r_ Vinyl frame ] ]
8
[] REMOVE THE AIR CONDITIONER
FROM THE CASE
IA] Remove and save the 2 screws from the
lower sides of the front grille.
FRONT
[] Remove the two control knobs.
FRONT
Grasp the lower corners of the grille while
pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge
toward you more than 3" or you may
damage the tabs of the grille.
t t
FRONT
r_ Remove the screw from each side of the
case. Keep them in a safe location.
FRONT