GE AEE08 Owner's Manual & Installation Instructions page 10

Window Installation Instructions
1711NSTALLTHE CASE IN THE
WINDOW
[_] Open the window and mark the centerline of
the window stool.
['_ Carefully place the case on the window stool
and align the center mark on the bottom front
with the centerline of the stool.
['_ Pull the window down behind the top
mounting rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
['_ Select the position that will place the sill
supports near the outermost point on the sill.
Place the short side of the sill supports, on the
case bottom, toward the window. Attach the
sill supports to the case track hole in relation
to the selected position using 2Type B screws
in each support.
-&CAUTION:
Do not install this air
conditioner in a window if the bolts do not
contact the window sill.
I I
Long side
of sill
supports
OUTSIDE
['_ Adjust the bolt and the nut in
each support so that the case is installed with
a slight tilt to the outside. Use a level; no more
than 1/2 bubble will be the correct case slant
to the outside.
-& CAUTION: Ifthe sill
support
bolts
do not contact the window sill or if you have a
window without a sill you must order accessory
kit RAK87 to properly install this air conditioner.
Call 800.626.2002 or visit ge.com.
[] INSTALLTHE CASE INTHE
WINDOW (CONT.)
['_ Secure the case to
the window stool
by using
3Type D screws. Sill _ ]_
support
Pull the accordion
i1.-i
panels to each
window sash track.
Attach them on each
side to the window
sash and the window
stool using
4Type C screws.
1-81 S ECURE THE CASE IN THE
WINDOW AND INSTALL THE
FOAM TOP WINDOW GASKET
IA].&CAUTION:
To prevent broken glass
or damage to windows,
on vinyl or other
similarly constructed
windows, attach the
support bracket to the
window side jam.
Vinyl
Attach the window
locking brackets
(one on each side)
with Type C screws.
Wood
[]
[]
Cut the foam top window gasket to the
window width.
Stuff the foam
between the glass
and the window to
prevent air and
insects from
getting into the
room.
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal.
10