Chapter 63 Modify Login Banner And Prompt Commands - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 63
config greeting_message {default}
show greeting_message
config command_prompt [<string 16> | username | default]
63-1 config greeting_message
Description
This command is used to modify the login banner.
Format
config greeting_message {default}
Parameters
default – (Optional) Adding this parameter to the config greeting_message command will return
the greeting message (banner) to its original factory default entry.
Restrictions

When users issue the "reset" command, the modified banner will remain in tact. Yet,
issuing the "reset system" will return the banner to its original default value.

The maximum character capacity for the banner is 24 lines with 80 characters per line.

In the following example, Ctrl+W will save the modified banner only to the DRAM. Users
must enter the "save" command to save this entry to the Flash memory.

Only Administrator and Operator-level users can issue this command.
Example
To edit the banner:
DGS-3620-28SC:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
===============================================================================
Copyright(C) 2012 D-Link Corporation. All rights reserved.
Modify Login Banner
and Prompt Commands
DGS-3620-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.015
697