Show Iproute; Create Ipv6Route - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
43-3

show iproute

Description
This command is used to display the switch's current IP routing table.
Format
show iproute {[<network_address> | <ipaddr>]} {[static | rip | ospf | bgp | hardware]}
Parameters
<network_address> - (Optional) Specifies the destination network address of the route want to
be displayed.
<ipaddr> - (Optional) Specifies the destination IP address of the route want to be displayed. The
longest prefix matched route will be displayed.
static - (Optional) Specifies to display only static routes. One static route may be active or
inactive.
rip - (Optional) Specifies to display only RIP routes.
ospf - (Optional) Specifies to display only OSPF routes.
bgp - (Optional) Specifies to display only BGP routes. (EI Mode Only Parameter)
hardware - (Optional) Specifies to display only the routes that have been written into the chip.
Restrictions
None.
Example
To display the contents of the IP routing table:
DGS-3620-28SC:admin#show iproute
Command: show iproute
Routing Table
IP Address/Netmask
------------------
10.0.0.0/8
Total Entries : 1
DGS-3620-28SC:admin#
43-4

create ipv6route

Description
This command is used to create an IPv6 static route in the switch's IP routing table. If the next hop
is a global address, it is not necessary to indicate the interface name. If the next hop is a link local
address, then the interface name must be specified.
Gateway Interface
--------------- ------------
0.0.0.0 System
509
Cost Protocol
-------- --------
1 Local