Debug Stp Show Flag - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
all - Display all port's counters.
If no parameter is specified, display the global counters.
Restrictions
Only Administrator level users can issue this command.
Example
To show the STP counters for port 9:
DGS-3620-28SC:admin# debug stp show counter ports 9
Command: debug stp show counter ports 9
STP Counters
--------------------------------------
Port 9 :
Receive:
Total STP Packets
Configuration BPDU
TCN BPDU
RSTP TC-Flag
RST BPDU
:32
Discard:
Total Discarded BPDU
Global STP Disabled
Port STP Disabled
Invalid Packet Format
Invalid Protocol
Configuration BPDU Length :0
TCN BPDU Length
RST BPDU Length
Invalid Type
Invalid Timers
DGS-3620-28SC:admin#

20-12 debug stp show flag

Description
This command used to display the STP debug level on specified ports.
Format
debug stp show flag {ports <portlist>}
Parameters
ports - (Optional) Specifies the STP ports to display.
<portlist> - (Optional) Enter the list of port used for this configuration here.
:32
:0
:0
:15
:32
:0
:0
:0
:0
:0
:0
:0
:0
:0
275
Transmit:
Total STP Packets
Configuration BPDU
TCN BPDU
RSTP TC-Flag
RST BPDU
:32
:0
:0
:7