Preferred Symbology Default; Output Sequence Overview; Require Output Sequence; Output Sequence Editor - Honeywell 1900GHD-2 User Manual

bar code has been encountered. Scan the bar code below, then set the
delay (from 1-3,000 milliseconds) by scanning digits from the inside back
cover, then scanning Save. Default = 500 ms.

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their
default values.

Output Sequence Overview

Require Output Sequence

When turned off, the bar code data will be output to the host as the scanner
decodes it. When turned on, all output data must conform to an edited
sequence or the scanner will not transmit the output data to the host
device.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.

Output Sequence Editor

This programming selection allows you to program the scanner to output
data (when scanning more than one symbol) in whatever order your appli-
cation requires, regardless of the order in which the bar codes are
scanned. Reading the Default Sequence symbol programs the scanner to
the Universal values, shown below. These are the defaults. Be certain
you want to delete or clear all formats before you read the Default
Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the
code I.D., code length, and character match(es) your application
requires. Use the Alphanumeric symbols (inside back cover) to read
these options. You must hold the trigger while reading each bar code
in the sequence.
4 - 22
Preferred Symbology Time-out
Preferred Symbology Default