Honeywell Xenon 1902G-BF Quick Start Manual

Xenon™ 1902G-BF
CCB01-010BT-BF
Battery-Free Wireless Area-Imaging Scanner and
Charge Base
Quick Start Guide
Aller à www.honeywellaidc.com pour le franç ais.
Vai a www.honeywellaidc.com per l'italiano.
Gehe zu www.honeywellaidc.com für Deutsch.
Ir a www.honeywellaidc.com para españ ol.
Para Portuguê s, acesse www.honeywellaidc.com.br.
Перейти на русскоязычный сайт www.honeywellaidc.com.
Pro češtinu jdi na www.honeywellaidc.com.
Pre slovenčinu choď na
www.honeywellaidc.com
日本語 : をご覧ください。
www.honeywellaidc.com
如要到中国 www.honeywellaidc.com（简体） 。
查看繁体版请登陆 www.honeywellaidc.com
한글 로 이동합니다 .
www.honeywellaidc.com
RS485:
Base LED Sequences and Meaning
Red LED - Host Communication
Red LED Condition
Off Power off, USB suspend
On continuously Power on, system idle
Short blinks. Occurs while Receiving data
transferring data to the host
port.
Note: Refer to your user's guide for information about cleaning your
device.
Getting Started
Turn off the computer's power before connecting the base, then
power up the computer once the base is fully connected. When the
base is connected and powered up, put the scanner in the base to
establish a link. The green LED on the base flashes to indicate the
scanner's instant charge pack is charging. The scanner must be
returned to the base when not in use. A scanner charged on the
base with the power supply for 35 seconds will result in 100 scans,
with one scan every second.
Power Supply Assembly (if included)
Note: The power supply must be ordered separately, if needed.
Rev (a)
11/16
LED Indicators - Scanner Instant Charge Pack
Green LED Yellow LED Condition
On continuously Battery has full charge
Slow blink Battery less than 100%
capacity
Fast blink Battery less than 50%
capacity
Fast blink Under 50 scans available
Off Off Scanner not in cradle
Reading Techniques
The view finder projects an aiming
beam that should be centered over
the bar code, but it can be posi-
tioned in any direction for a good
read.
Hold the scanner over the bar code,
pull the trigger, and center the aim-
ing beam on the bar code.
The aiming beam is smaller when
the scanner is closer to the code and larger when it is farther from
the code. Hold the scanner close to smaller bar codes, and farther
away from large bar codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need to
tilt the scanner at an angle so the bar code can be scanned.
Note: If the scanner beeps 3 times when scanning a bar code, the
link has not been established. If the scanner beeps once, the
link has been established.
Connecting the Scanner
USB:
Note: If you are charging the scanner using the USB cable, the
current available for charging is reduced and charge times are
increased. Charging via the power supply is faster.
Keyboard Wedge:
RS232 Serial Port: