Low Priority Symbology; Preferred Symbology Time-Out; Preferred Symbology Default - Honeywell Captuvo SL22 User Manual

Low Priority Symbology

To specify the low priority symbology, scan the Low Priority Symbology bar
code below. On the Symbology Chart on page A-1, find the symbology you
want to set as low priority. Locate the Hex value for that symbology and
scan the 2 digit hex value from the Programming Chart (inside back cover).
If you want to set additional low priority symbologies, scan FF, then scan
the 2 digit hex value from the Programming Chart for the next symbology.
You can program up to 5 low priority symbologies. Scan Save to save your
selection. Default = None
Low Priority Symbology

Preferred Symbology Time-out

Once you have enabled Preferred Symbology and entered the high and low
priority symbologies, you must set the time-out period. This is the period of
time the sled will search for a high priority bar code after a low priority bar
code has been encountered. Scan the bar code below, then set the delay
(from 1-3,000 milliseconds) by scanning digits from the inside back cover,
then scanning Save. Default = 500 ms.
Preferred Symbology Time-out

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their
default values.
Preferred Symbology Default
2 - 5