Figure; Show All Groups - Linksys 4116 - EtherFast Switch User Manual

Chapter 1 Using the Cisco Multicast Manager
•
•
•
The following section describes router-specific diagnostics:
•

Show All Groups

With the Show All Groups page, you can:
1.
2.
3.
4.

Figure 1-44

(Optional) If you are using S,G caching, the cache contents appear. Click Refresh Cache to refresh the
table of sources and groups.
If there are a lot of sources and groups present, you can filter the display to show only those you are
interested in:
•
OL-7348-01
Health Check, page 1-73
6500 Troubleshooting, page 1-73
Top Talkers, page 1-75
Router Diagnostics, page 1-77
View all of the active sources and groups in the network in tabular format. Groups are listed in
numerical order, and the number of sources for each group appears in the last column. If there is
more than one source for a group, click Sources to view them all.
Draw complete graphical trees by clicking on a group.
Draw filtered graphical trees by selecting the Source, Group, FHR and LHR.
Plot the pps/bps for a particular source and group.
Multicast Diagnostics
Source—Enter or select the IP address of the source to monitor.
Using the Multicast Manager Tool
User Guide for the Cisco Multicast Manager 2.3.3
1-61