Address Management - Linksys 4116 - EtherFast Switch User Manual

Chapter 1 Using the Cisco Multicast Manager
Using the Administration Tool
Figure 1-14 Trap Receiver/Email Polling Configuration
You can add or remove trap receivers using the Configure Domain Specific SNMP Trap Receivers
section. The SNMP trap receivers specified here are only used if global SNMP trap receivers are not
specified. Global trap receivers are specified from the Configure Global Default SNMP Trap Receivers
page (see the "Global Polling Configuration" section on page 1-23).
You can add or remove Email addresses using the Configure Domain Specific Email Addresses for
Event Notification section. Email addresses are notified of SSG exceptions and threshold and existence
events. The Email addresses specified here are only used if global Email addresses are not specified.
Global Email addresses are specified from the Configure Global Default SNMP Trap Receivers page (see
the "Global Polling Configuration" section on page 1-23).

Address Management

Using the Address Management page, you can enter multicast group and source addresses into the
database with a description. When the CMM displays these sources and groups, the descriptions will be
added for easy recognition.
The database is pre-populated with all of the reserved address space.
User Guide for the Cisco Multicast Manager 2.3.3
1-27
OL-7348-01