Linux Installation Instructions - Linksys 4116 - EtherFast Switch User Manual

Linux Installation Instructions

Output from a sample installation:
#=====[ Sample Installation ]=====#
root@ganymede/export/home/mike/mmtinstall-> ./setup.sh
Installing Cisco Multicast Manager Version 2.1
Copyright (c) 2003-2004 Cisco Systems, Inc. All Rights Reserved.
The application installs in /opt/RMSMMT. Do you wish to continue? [y/n]: y
Creating mmtuser gid...
Creating mmtuser uid...
Locking mmtuser account...
Installing Apache...
Installing Perl...
Installing MIBS...
Installing support files...
Installing K98mmt to /etc/rc0.d to ensure proper shutdown of application...
Would you like the S98mmt script installed in /etc/rc3.d to start the application upon
system boot? [y/n]: y
Seeding IP Address database with reserved Multicast Addresses...
Modifying httpd.conf file for this system...
Installation Finished.
Linux Installation Instructions
To install the CMM for Red Hat Enterprise Linux AS Release 3 (Taroon Update 4), log in as the root
user and follow one of the approaches outlined below.
Approximately 300MB of disk space is required for installation.
Note
1.
2.
User Guide for the Cisco Multicast Manager 2.3.3
1-4
Install the CMM in the following directory:
/usr/local/netman
If there is not enough room in the /usr/local directory, create the netman directory on another
partition and create a symbolic link to it from /usr/local. For example:
# mkdir /space/netman
# cd /usr/local
# ln -s /space/netman netman
# chown -h mmtuser:mmtuser netman
If you symbolically link /usr/local/netman to the actual installation directory as shown above, when
installation is complete, you must cd to the actual installation directory, similar to:
# cd /space
and issue the following command:
# chown -R mmtuser:mmtuser netman
Otherwise, the installation will create the directory and set the ownership for you.
If you are installing from the CDROM, enter:
# cd /mnt/cdrom
# ./setup.sh
Chapter 1 Using the Cisco Multicast Manager
OL-7348-01