Rpf Polling - Linksys 4116 - EtherFast Switch User Manual

Using the Administration Tool

RPF Polling

Using the CMM, you can monitor RPF failures for a particular source and group on any selected router.
If any monitored source and group begins to experience RPF failures that rise above the delta, then
SNMP traps can be sent, and a report generated, which you can view under RPF Failures (see the
Failures" section on page
You can select the source and group from the list, or you can enter them manually. If there are a lot of
sources and/or groups, you can use the filter option, to ensure you are selecting an S,G that actually
exists in the network. The filter option displays only the sources for a selected group, or only the groups
for a selected source. To reset the lists, click Reset S,G Lists.
Figure 1-18
The RP Failure Polling Configuration page contains:
Fields and Buttons
Refresh Status
Start
Stop
Restart
User Guide for the Cisco Multicast Manager 2.3.3
1-32
1-51).
RPF Failure Polling Configuration
Chapter 1 Using the Cisco Multicast Manager
Description
The status line indicates how long the polling
daemon has been running and how it was started.
Click Refresh Status to update the status
information.
Starts the polling daemon globally.
Stops the polling daemon globally.
Restarts the polling daemon globally. Each time
you change a polling interval, click Restart.
"RPF
OL-7348-01