Table of Contents
Advertisement
DIALING AND TRANSMISSION
SPEED DIALING
Speed Dialing is done using the SPEED DIAL key and the numeric keys on the lefl side of the
panel. Any of code numbers 01 through 50 may be dialed. (Note that numbers 01 through 20 may
be dialed both by Speed Dialing and by Rapid Key Dialing.)
1.
To dial, press the SPEED DIAL key and then enter the two digits of the code number
using the numeric keys. To enter numbers
1 through 9, first enter 0 and then the
number. Do not pick up the handset or press the SPEAKER
key.
2.
Check the display. If the name or number shown is correct, press the START/COPY
key and the document will be transmitted.
If it is incorrect, press the STOP key.
ABOUT NUMBER
ENTRY
See "Fax and voice numbers for automatic
dialing" in Chapter 5 for the procedure
for entering
numbers into the Autodialer
of the FO-130. For each code number, you may enter a fax or voice
number and a name (this appears in the display when the number is called).
Redialing when the line is busy
REDIAL KEY
If the line is busy, you can press the REDIAL key to redial the number. This can be used with any
of the methods of dialing described above.
The REDIAL key works the same way as Normal Dialing using the SPEAKER
key:
1.
Press the REDIAL key.
2.
Wait for the connection.
Depending on the setting of the receiving machine, you will
either hear a facsimile Reception Tone or the other person will answer.
l
If the other person answers, pick up the handset and ask them to press their Start
key. This causes the other machine to issue a Reception Tone.
3.
When you hear the Reception
Tone, press the START/COPY
key. Replace
the
handset if you used it.
a)
Note:
w If you do any programming
operations after attempting
to dial, you will not be able to use the
REDIAL key (programming
erases the numberfrom
memov).
3-8
BASIC OPERATIONS
Advertisement
Table of Contents
