Leds - Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual

Troubleshooting
This chapter describes how to troubleshoot the universal gateway by referring to the LEDs on feature
cards and using the bantam jack ports. The chapter contains the following sections:
•
•
•
•
•
•
•
•
•

LEDs

The LEDs indicate the current operating condition of the feature cards. Observe the LEDs (see
Figure 7-1
contact your system administrator or a customer service representative. (See the
Assistance" section on page
Figure 7-1
78-17406-01
LEDs, page 7-1
Mixing WAN Feature Cards, page 7-5
Mixing Universal Port and Dial-Only Feature Cards, page 7-6
Mixing Voice Feature Cards With Universal Port and Dial-Only Feature Cards, page 7-6
Monitoring the Chassis Environment, page 7-7
Using the Bantam Jack Ports to Monitor T1, E1, and CT3 Feature Cards, page 7-10
Using Drop and Insert Mode on the CT3 Feature Card, page 7-10
Troubleshooting Network Interfaces, page 7-11
Getting Help, page 7-11
through Figure 7-4), note any fault condition that the product is encountering, and then
xvi, if necessary.)
2-Port or 4-Port T1 or E1 Feature Card LEDs (2-Port T1 or E1 Feature Card Shown)
0
1
0
1
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
C H A P T E R
Table 7-1 describes the LEDs.
ACTIVITY (ACT)
OK/MAINT
7
"Obtaining Technical
7-1