Digital Signal Processor Firmware; Getting Help; Where To Go Next; Chapter 7 Troubleshooting - Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual

Chapter 6 Voice Feature Card
Figure 6-15 Installing PVDM2 Modules in the Voice Feature Card
Repeat
Step 6
Note

Digital Signal Processor Firmware

Digital signal processor (DSP) firmware is automatically downloaded to the voice feature card from the
Cisco IOS image when you boot the system for the first time, or when you insert a voice feature card
while the system is operating. When you insert feature cards while the system is operating, the Cisco IOS
image recognizes the cards and downloads the required firmware to the cards.
For more information on voice feature card firmware and upgrade options, see the
Cisco AS5400XM Universal Gateways Software Configuration

Getting Help

For information about technical support, onsite service, and exchange and repair services, see the
"Obtaining Technical Assistance" section on page

Where to Go Next

The remaining chapters of this guide include information on troubleshooting feature cards and building
cables.
•
•
78-17406-01
View from front of board
Step 2 through Step 5 for each PVDM2 module.
When the voice feature card is installed and running, you can check that the PVDM2 modules
are installed correctly by entering the show voice dsp summary command. If an installed
PVDM2 module is missing from the output, try reseating the PVDM2 module.
Chapter 7, "Troubleshooting"
Appendix A, "Cabling Specifications"
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
1. Insert the PVDM2 into the socket
at an angle from vertical.
2. Push the top of the PVDM2
down and back.
3. The socket guide posts fit through
the holes in the PVDM2.
4. The locking springs clip the back
of the PVDM2.
Guide.
xvi.
Digital Signal Processor Firmware
Cisco AS5350XM and
6-11