Configuring Input Impedance For The E1 Feature Card; Configuration - Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual

Chapter 3 T1 and E1 Feature Cards
For information about configuring the T1 or E1 ports, see the
Note
Universal Gateways Software Configuration

Configuring Input Impedance for the E1 Feature Card

You can set the input impedance of the E1 feature card before or after running the setup script. For
information on configuring the universal gateway with the setup script, see the
Cisco AS5400XM Universal Gateways Software Configuration

Configuration

To set the input impedance for the E1 feature card, use the line-termination command.
Command
Step 1
Router> enable
Password: password
Router#
Step 2
Router# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
Router(config)#
Step 3
Router(config)# controller e1 0
Router(config-controller)#
Step 4
Router(config-controller)# line-termination
75-ohm
Step 5
Router(config-controller)# Ctrl-Z
Router#
%SYS-5-CONFIG_I: Configured from console by
console
78-17406-01
Guide.
Purpose
Enters enable mode.
Enter the password. You have entered enable mode when
the prompt changes to
Enters global configuration mode. You have entered
global configuration mode when the prompt changes to
Router(config)#.
Enter the controller number on which you are configuring
input impedance.
Sets the input impedance to 75 ohm for the controller.
The factory-set default is 120 ohm. Repeat Step 3 and
Step 4 for the other controllers.
Returns to enable mode.
This message is normal and does not indicate an error.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
Configuring Input Impedance for the E1 Feature Card
Cisco AS5350XM and Cisco AS5400XM
Cisco AS5350XM and
Guide.
.
Router#
3-11