Online Insertion And Removal Of The Universal Port Or Dial-Only Feature Card; Removing The Universal Port Or Dial-Only Feature Card - Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual

Universal gateways

Hide thumbs Also See for AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle:

Quick start manual (69 pages)

Regulatory compliance and safety information manual (68 pages)

Installing manual (16 pages)

Table Of Contents

100

101

102

103

104

Table of Contents

Chapter 5

Universal Port and Dial-Only Feature Cards

Online Insertion and Removal of the Universal Port or Dial-Only

Feature Card

To remove a feature card without dropping any calls or connections, you will need to take the feature

card out of service by using the busyout command to disable the feature card. The busyout command is

executed on a per–feature card basis and will disable the card after waiting for the active services to

terminate.

If there are active calls on the feature card after you execute the busyout command, wait for the calls to

drop. To view the status of the termination process, use the show busyout command.

The online installation and removal (OIR) of new cards should be done only during times of low CPU

Caution

utilization, such as during maintenance.

To avoid erroneous failure messages, remove or insert only one feature card at a time.

Caution

When you replace a feature card in a slot with a new feature card of the same type, the system software

recognizes the new feature card and brings up the trunk interfaces automatically.

If you replace the existing feature card with a new feature card of a different type, you must reconfigure

the system. For configuration details, see the

Gateways Software Configuration

Monitoring Voice and Fax Services on the Cisco AS5350 and Cisco AS5400 Universal Gateways

document.

Removing the Universal Port or Dial-Only Feature Card

To remove the universal port or dial-only feature card, follow these steps.

An example showing the output from each command is provided after the procedure. See the

Note

Insertion and Removal Example for the Universal Port or Dial-Only Feature Card" section on page

Determine which slot the feature card is in (see

Step 1

slot command in privileged EXEC mode:

Router# show chassis slot

Note

78-17406-01

These commands are not valid for slot 0. Slot 0 is the motherboard.

Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide