System Messages - Cisco 2811 - Voice Security Bundle Router Hardware Manual

System Messages

Table 2 LED Indicators on Cisco 2800 Series Routers (continued)
LED Indicator State
AIM0 Off
AIM1
Green
(Advanced integration
modules)
Amber
1. The 3 blinks+pause state is applicable to the Cisco 2821 and Cisco 2851 routers only. The Cisco 2801 and Cisco 2811 do not have 1000 Mbps ethernet
ports.
2. The PVDM2 LED is applicable only to the Cisco 2821 and Cisco 2851 routers.
System Messages
This section describes system error and recovery messages that may appear when a Cisco 2800 series
router is operated. Cisco IOS software displays system error and recovery messages on an external
device console terminal screen. (For more information, see the
Modem" section on page
The terminal should display one of the following prompts:
Router>
or
Router#
The Cisco IOS software checks the system condition once every 30 seconds. If the condition still exists,
the error message appears again; if the error condition has cleared, a recovery message appears.
Table 3
Table 3
Note
occur in your router, see the
Module LEDs" section on page
Troubleshooting Cisco 2800 Series Routers
8
Meaning
No AIM installed in slot
(0, 1).
AIM in slot (0, 1) is
initialized.
AIM in slot (0, 1) failed to
initialize.
12.)
(indicates the user EXEC command mode)
(indicates the privileged EXEC command mode)
describes system error and recovery messages and LED conditions that might accompany them.
does not provide a complete list of system LED conditions. (For all LED conditions that can
"Reading System LEDs" section on page 4
7.)
Corrective Action
Indication is for information only.
Normal indication. No action required.
Replace the AIM. To replace the AIM, refer to the
"Installing and Removing AIMs"
"Installing and Upgrading Internal Modules in
Cisco 2800 Series Routers" online document.
"Connecting to a Console Terminal or
and the
section of the
"Reading Port and
OL-5789-01