Cisco 2811 - Voice Security Bundle Router Hardware Manual page 104

Reading System LEDs
Table 1 System LEDs on Cisco 2800 Series Routers (continued)
LED
Indicator State
AUX/PWR Off
Solid green
Solid amber
SYS ACT Off
Blinking
CF Off
Solid green or
blinking
Troubleshooting Cisco 2800 Series Routers
6
Meaning
IP power is not installed, and
RPS is not connected or not
powered up.
IP power is functional, if
installed.
RPS is functional, if connected.
If RPS backup is not
connected, IP power output has
failed.
If IP power is not installed,
RPS has failed.
If RPS backup is connected and
IP power is installed, either one
or both has failed.
No packet transfers are
occurring.
System is actively transferring
packets or is monitoring
internal activities.
The flash memory is not being
accessed.
The flash memory is being
accessed.
Possible Causes and Corrective Actions
If RPS is connected, power it up to provide backup power.
Otherwise, no action is required.
Normal indication. No action required for IP power or RPS.
Replace AC power supply. Refer to the
Power Supply" section of the
Internal Modules in Cisco 2800 Series
document.
Repair or replace the RPS. Refer to the Cisco RPS-675
Document.
Check RPS, and repair or replace if faulty. Refer to the
Cisco RPS-675 Document.
Check AC power supply, and replace if faulty. Refer to the
"Replacing the Power Supply"
and Upgrading Internal Modules in Cisco 2800 Series
Routers" online document.
Ethernet not active or not connected. Check Ethernet
connections and make corrections as necessary.
Router not configured properly. Check configuration and
make corrections as necessary.
Normal indication. No action required.
Normal indication. No action required. It is okay to remove
the CompactFlash memory card if the CF LED remains off.
Normal indication. No action required.
Caution: Do not remove the CompactFlash memory card
while it is being accessed.
"Replacing the
"Installing and Upgrading
Routers" online
section of the "Installing
OL-5789-01