Installing And Removing Aims; Installing The Chassis; Cover" Section On Page - Cisco 2811 - Voice Security Bundle Router Hardware Manual

Installing and Removing AIMs

Figure 16
1
If you are finished installing modules, install the cover on the router. See the
Step 6

Cover" section on page

Installing and Removing AIMs
AIMs plug into an AIM connector on the system board as described in the
on page
apply the label to the chassis as described in the
Before you remove or install an AIM, remove the chassis cover as described in the
Chassis Cover" section on page
Table 1
Cisco Part Number
AIM-ATM=
ATM-COMPR2-V2=
AIM-CUE=
AIM-VPN-EPII-PLUS
When you remove or install an AIM, always wear an ESD-preventive wrist strap, and ensure that it
Caution
makes good contact with your skin. Connect the equipment end of the wrist strap to the metal part of the
chassis.
Caution Handle AIMs by the edges only. AIMs are ESD-sensitive components and can be damaged by
mishandling.
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
16
Installing a DRAM DIMM
2
Insert the DRAM DIMM
51.
18. Each AIM sold as a spare is supplied with a label that identifies the AIM type. Be sure to
AIMs Supported on Cisco 2800 Routers
1
2 Close the latches
"Applying the AIM Label" section on page
2.
Type
ATM
Compression
Unity Express
VPN Encryption
2

"Installing the Chassis

"Installing an AIM" section
26.
"Removing the
OL-5792-04