Diagnostic Ping Window; Using Discovery Oui - NETGEAR WMS5316 - ProSafe 16-AP Wireless Management System Reference Manual

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual
Select one of the managed access points to display System Log.
Note: Access point system logs are not supported for access point model WG602v4. If
you try to display system logs for that model access point, the display window is
empty.
The System Log Window can be refreshed by using the Refresh button.

Diagnostic Ping Window

This window provides a way to verify ping connectivity from the Wireless Management System to
a managed access point. A managed access point can be selected from the available drop down list.
The IP address of the access point to be pinged is displayed in the non-editable IP Address field.
Figure 7-18
1. Specify the number of pings to be tried in the Ping Count field.
2. Click Start to begin pinging the selected access point.
3. When you are finished, click Cancel to stop the pinging.

Using Discovery OUI

The Wireless Management System discovers NETGEAR access points on the LAN from the OUI
(Organizationally Unique Identifier) of their unique MAC addresses. The first half of the MAC
address is the OUI. Usually, this happens without incident during discovery. OUIs are allocated to
businesses that produce products with MAC addresses.
Maintenance
v1.0, March 2010
7-15