Table of Contents
Advertisement
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
<MatrixPort>1</MatrixPort>
<IdleTimeout>0</IdleTimeout>
<InstantReplay>0</InstantRepla
<TimeDateFormat>0</TimeDateFormat>
<MacroBase>60</MacroBase>
</Keyboard>
Note:
Make sure to allow access to all users when creating a new macro.
Failover Configuration with a Pelco Matrix Switch
This section describes how to configure a hybrid soluti
based N+N redundancy.
Note:
The example in this section f
to other Pelco systems.
Figure 72 shows how an ISP can act as a failover recorder for other ISPs by using a Pelco 9700
matrix switch.
Figure 72.
Pelco H
ybrid Failover Solution
The following equipment and software is required to configure failover with a Pelco matrix switch:
●
A dedicated ISP for failover
●
The Cisco Stream Manager A
●
A Pelco matrix switch with available output ports
●
An additional data converter between the failover
y>
on with a Pelco matrix switch for a matrix-
ocuses on the CM9700 matrix switch, but similar steps apply
dministration and Monitoring with Failover Module
ISP and the Pelco matrix switch
Design Guide
6-19
Page-6-19
Advertisement
Table of Contents
