Table of Contents
Advertisement
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Figure 35 shows the icon that indicates that ISP_2 has been configured as a failover device.
Figure 35.
Configuration Module
Configure Video Loss Detection
The previous section describes how to configure an ISP to detect complete ISP failures. To detect
when video is lost from individual ports, each port in the environment must be configured to send
an alarm to the Stream Manager Administration and Monitoring Module if video loss is detected.
Figure 36 shows the configuration that is required for each ISP port.
Figure 36.
Video Loss Detection
Design Guide
5-12
Page-5-12
Advertisement
Table of Contents
