Table of Contents
Advertisement
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Figure 61.
Bosch Hybrid Failover Solution
The following equipment and software is required for this solution:
●
A dedicated ISP for failover.
●
The Cisco Stream Manager Administration and Monitoring with Failover Module.
●
A Bosch matrix switch with available output ports.
●
RS-232 console cable to connect from the matrix switch to the failover ISP. This cable
carries instructions for the matrix switch to redirect video streams to the failover ISP. This
cable may be purchased directly from Bosch or built by using the pinouts that are shown in
Table 9.
Table 9.
RS-232 Serial Cable Pinout
Pin Number
Allegiant Designation
1
CHASSIS GND
2
Receive
3
Transmit
4
CTS
5
RTS
6
NO CONNECTION
7
DATA GND
8
NO CONNECTION
9
NO CONNECTION
By default, the 16 input ports of the LTC 8200 are configured as Camera 1 through Camera 16.
These ports numbers must match the camera number or peripheral ID of the encoder port on the
ISP. In an environment with more than 16 cameras or with camera numbers that are greater than
9-Pin Female (ISP Side)
None
Data 3
Data 2
1
8
None
5
None
None
(pins 4 & 6 jumpered)
(pins 1 & 7 jumpered)
Design Guide
6-10
Page-6-10
Advertisement
Table of Contents
