1. Connect the appropriate interface cable to the base first and then to the
computer. Make sure the cables are secured in the wireways in the bottom
of the base and that the base sits flat on a horizontal surface.
2. Program the base for the USB interface by scanning the appropriate
programming barcode See
3. Verify the base operation by scanning a barcode from the
in the back of this manual.
For additional USB programming and technical information, refer to the Honey-
well "USB Application Note," available at
Connecting the Base with Keyboard Wedge
1. Turn off power and disconnect the keyboard cable from the back of the ter-
minal/computer.
1 - 4
page
2-5.
www.honeywell.com/aidc
Sample Symbols
.