and then set the time-out duration (from 0-3000 seconds) by scanning digits on
the
Programming Chart
sec (no alarm).
Base Alarm Duration
Note: If you are out of range when you scan a barcode, you will receive an error
beep even if you do not have the alarm set. You receive the error beep
since the data could not be communicated to the base or the host.
Alarm Sound Type
If you have set the out-of-range alarm enabled, you may change the alarm type
for the image scanner or base by scanning the appropriate barcode below and
then scanning a digit (0-7) barcode and the Save barcode on the
Chart
inside the back cover of this manual. Default = 0. Set the sound type to fit
your application.
Base Alarm Type
inside the back cover, then scanning Save. Default = 0
Image Scanner Alarm Duration
Image Scanner Alarm Type
Programming
3 - 21